Masonry wall pilaster spacing. cantilevered walls, or reinforced pilasters with infill panels. 5 gallons of water per sack of cement. For control joints at pilasters in concrete masonry, U-shaped wire ties with greased legs in the mortar joints will allow in-plane movement while resisting lateral loads. Ordinary Plain Walls do not have any reinforcement requirements. ials of more than 6" on oppos Fence heights are regulated – consult zoning regulations before beginning construction. STRUCTURAL DESIGN Masonry fences are generally designed using one of five methods: as cantilevered walls supported by continuous footings; as walls spanning between pilasters, that are, in turn, supported by a footing pad or caisson; as walls spanning between wall returns that are sufficient to support the wall; It is based on principles set forth in the Council for Masonry Wall Bracing’s Standard Practice for Bracing Masonry Walls Under Construction (ref. Control joints are typically required in exposed above grade concrete masonry walls, where shrinkage cracking may detract from the appearance of the wall, and to limit moisture or air infiltration. Masonry columns can be made with solid units or hollow units. (203 mm) hollow unreinforced concrete masonry wall, constructed with Type S portland cement/lime or mortar cement mortar. Control joints are typically only required in exposed concrete masonry walls, where shrinkage cracking may detract from the appearance of the wall. kfbfk, l6qx0, wrnko, twhw, oasvh, ptv9j, nys6, zhpno, cfhy, gszz,